Snap Style Installation- Labor Saving,for Confined Areas
Built for electrical contractors, wholesale distributors and MRO buyers who wire non-metallic sheathed cable, this snap-in connector seats into a standard knockout and locks with finger pressure. No locknut, no screwdriver, no thread chasing, and no reaching behind a crowded box to hold a ring while the other hand works a wrench.
The body is moulded in one piece from non-conductive plastic, so there is no sharp die-cast edge to nick the sheath and no metal part to bond. A split ring collapses as the connector enters the knockout and springs back to hold it, while an internal jaw grips the cable jacket and takes the pull that rough-in crews put on a run.
Two trade sizes cover the everyday NM range: 1/2 inch for 14/2 and 12/2 branch circuits, 3/4 inch for larger feeders and multi-cable pulls. Both seat in the matching knockout, accept one or two cables into the same body, and carry the cETLus mark for the United States and Canada, so a single SKU line serves both markets.
A locknut connector costs a contractor a wrench, a reach behind the box and a dropped ring in the wall cavity. This one goes in from the front with two fingers, holds while the cable is pushed home, and comes back out with a twist of a screwdriver when a circuit is re-routed, so the part is never scrapped during a change order.
Each lot is cETLus Listed by Intertek and ships with the certificate pack on request for inspection files. MOQ 1,000 pcs per size, 15-25 day production, FOB Ningbo or Shanghai. OEM private label, custom colour, printed bags and mixed-size cartons are available for distributors and importers building their own SKU line.
Non-Metallic Cable Connector
Snap Style Installation - Labor Saving, for Confined Areas
| ITEM NO. | SIZE |
| DLK-1 | Grey 1/2'' |
| DLK-2 | Red 3/4'' |