All Categories

Non-Metallic Liquid Tight Conduit Angle 90° Connector 3/8''-2'' Threaded PVC Electrical Elbow and Straight Conduit Fittings

Used to connect non-metallicliquid tightconduit andflexible non-metallic tubing to enclosure

Description

Two connector bodies, one family. A straight and a 90 degree angle, both non-metallic and liquid tight, in seven trade sizes from 3/8 to 2 inch, sized to the same conduit they screw onto, so thread and sealing face match across the whole run. Order both and a job that needs a clean entry at one end and a tight turn at the other is closed with no adapter and no second purchase order.

Both take a male thread into the knockout and a compression nut onto the conduit, so the seal is made at the two places water actually enters: the enclosure wall and the jacket. No metal in the body to rust at a coastal wall or a wash-down bay, and no metal path to bond. The angle turns the run at the fitting, not inside a shallow box.

The straight covers a panel entry where the conduit drops in square. The angle takes over where a straight body would need a bend radius the box does not have: a shallow enclosure, a wall corner, a motor terminal box with the knockout on its side. Same seven sizes across both, so the spare in the van fits either body and either end of the run.

Most callbacks on a liquid tight run come from the joint, not from the conduit. A fitting that will not seat squarely because the cut end was not round, or a thread that bottoms out before the sealing washer touches, will weep for years. The nut here is moulded to be turned by hand, so nothing on the body needs a wrench that would ovalise the thread.

Standards are quoted only where the file exists. If the job specifies a UL or CSA file for the fittings, ask at quotation and we will send what the factory holds. Gray is standard, black on request. Cartons can be mixed across the seven sizes so one shelf pack covers both bodies, your part number can go on the label, and lead time is 15 to 25 days from Ningbo or Shanghai.

Non-Metallic Liquid Tight Straight Connector

Used to connect non-metallic liquid tight conduit and flexible non-metallic tubing to enclosure

ITEM NO. SIZE
ANT-S38 3/8"
ANT-S50 1/2"
ANT-S75 3/4"
ANT-S100 1"
ANT-S125 1-1/4"
ANT-S150 1-1/2"
ANT-S200 2"

Non-Metallic Liquid Tight Angle 90° Connector

Used to connect non-metallic liquid tight conduit and flexible non-metallic tubing to enclosure

ITEM NO. SIZE
ANT-D38 3/8"
ANT-D50 1/2"
ANT-D75 3/4"
ANT-D100 1"
ANT-D125 1-1/4"
ANT-D150 1-1/2"
ANT-D200 2"

Get a Free Quote

Our representative will contact you soon.
Email
Name
Company Name
Message
0/1000

Product Recommended